Lichtlaerm Audio PandorA Preamp/Rack Amplifier

Designed to be a great tool for any setup, the PandorA is the modern solution for portable setups.

A 60W power amp that runs from 12-24V, cares neither about polarity nor about AC or DC: it just works. In contrast to other solid-state power amps, it is designed to amplify analog setups rather than modelers: PandorA has a built-in, analog impedance curve approximation and a negative feedback loop with presence and depth controls just like a tube amp. Just run a preamp pedal, distortion, or EQ into it for a full setup - even with your guitar plugged straight into it, it sounds amazing and will be loud enough to hang with a drummer!

Built with the TPA3118-chip, a very powerful and efficient amplifier, a lot of support circuitry was added to buffer the incoming signal and both shape it and pre-amplify it to maximize the output of the PandorA. Just plug it right into a guitar cabinet (minimum 8 Ohm) and create the smallest, most portable full live-setup ever seen. Use it with stereo effects or a splitter to create stereo- or wet/dry-setups with ease!

To accommodate different power supplies, a rectifier circuit and lots of power filtering were added, creating a circuit that allows a wide range of power: center-negative, center-positive, AC-voltage, DC-voltage, and anywhere from 12-24V with added headroom at higher voltages. A footswitch was also added to mute the signal if needed! It’s as simple as it is useful!

Features:

• Mute footswitch
• Runs from 12-24V (AC&DC, no matter the polarity)
• 60W at 8 Ohm (30W at 16 Ohm)
• Negative feedback path modeled after a tube amp
• Level controls master volume
• Presence & depth controls
• Designed for analog setups